Replace faulty flasher relay?

[Guest]

Can I replace my faulty stock flasher relay on my 80 gs1100 with one from the auto store? Any particular brand or stock number?

[cowboyup3371]

Yep and nope. But if you look on Basscliff's site he has some good information about doing it.

And do a search here, in fact I listed one awhile back that is working for mine. Just remember that if you have the self-cancelling signals they won't work typically after doing so.

[Guest]

I don't have the self cancelling feature on mine. The switches are gsxr. Its my gsxr/bandit conversion.

[BassCliff]

Hi,

This is what I did:

Turn Signal Relay Replacement

Have a look here:

*Electrical Odds and Ends*

Look just below the "Stock Bulbs" section. Sometimes you can replace the stock flasher with a generic two-prong "can" flasher and it will fit in the stock socket.


Thank you for your indulgence,

BassCliff

[Guest]

Thanks, Basscliff

As usual, you're the man........

Thanks, Paul

[Fluffyshanyn]

Basscliff,
Forgive me if I seem intrusive, but if I may ask......
Would this technique you linked to work on a '79 850? I have been around the manual, inside and out, and cannot see anything else other than my relay is bad. My fuses are good, the lights are receiving power/signal...but refuse to blink. The lights will turn solid for left or right, respectively, but will not blink. After a good hour chasing wires and arguing with my multimeter, I whittled it down to my turn signal relay. The problem then results in A.) the OEM part is painfully expensive, and B.) my local shop insists this is the only part that will work. If you could answer this, or at least point me in the direction of someone who can help me, it would be much obliged.

Thanks!
fluffyshanyn

[BassCliff]

Hi,

Basscliff,
Forgive me if I seem intrusive, but if I may ask......
Would this technique you linked to work on a '79 850?

Yes, a generic aftermarket flasher relay can be wired in place of the stock Suzuki part. Your bike is similar enough that my procedure should help you. Are you using all stock bulbs?

Again, I encourage you to start your own thread.


Thank you for your indulgence,

BassCliff

[Fluffyshanyn]

Hi,



Yes, a generic aftermarket flasher relay can be wired in place of the stock Suzuki part. Your bike is similar enough that my procedure should help you. Are you using all stock bulbs?

Again, I encourage you to start your own thread.


Thank you for your indulgence,

BassCliff

Ok, I'll probably create a new thread. I made one about my other electrical issue, so maybe I'll just condense the turn signal into there too...I'll use the tutorial, the only thing that might not work I the fact I don't have the same turn signal relay as you.....but it is worth a shot.

Thank you kindly!
Fluffyshanyn

[rustybronco]

Looking forward to your new thread.

[Camicus]

I realize that I am adding this comment 6 years after the thread was started but I wish I knew before what I know now.
Being that I am in Canada, I was not able to get the Tridon EP34 so I tried the Novita EP34-C. I was told Novita and Tridon are the same company and the EP34-C is the same as the EP34.
I used BassCliff's "Turn Signal Relay Replacement" link above but it wouldn't work. For the Novita EP34-C, you will need to connect "E" to the Ground, "L" to the Blue wire and "B" to the Orange wire. I am using 2006 GSX-R 1000 controls with LED signals and works great.
Thanks BassCliff for your link - it got me 90% there.