I got a free set of new grey Dyna coils & was wondering if they would work on my 80 GS1100E or my 83 GS1100S Katana. I believe they are the 2.2 ohm coils
-
-
2.2 ohm coils will work if you can add a couple of ballast resistors in line.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection -
What type of resistors are you talking about, the porcelain auto type or what ? What ohm resitors, Im not too good at this electrical stuff on bikes even though I was a journeyman lineman ?Comment
-
Yes, auto type. 1 - 1.5 ohm would be about right.
To figure out what resistance please look in your service manual for the OEM coil specs. For example, if the specs say you should have 3 ohm coils, then you need 1 ohm ballast resistors.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-ResurrectionComment
-
It says 3 ohm coils are on it now. Thanks for the help.Comment
Comment