Hi I installed new black Renthal Ultra Low handle bars and after market throttle/ hand grips and on my bike. When I tighten the switch down the starter button does not work. Any ideas? Do I have to sand the black off the handle bars under the switch?
-
Last edited by Guest; 07-16-2012, 03:09 PM. -
Wire pinched and its grounding off the bars...reset the wiring inside the switch and mark the area on the bars where the switch clamps on and give it a few wraps of electrical tape. Slide switch back into position and tighten down. Trim any tape sticking out off.MY BIKES..1977 GS 750 B, 1978 GS 1000 C (X2)
1978 GS 1000 E, 1979 GS 1000 S, 1973 Yamaha TX 750, 1977 Kawasaki KZ 650B1, 1975 Honda GL1000 Goldwing, 1983 CB 650SC Nighthawk, 1972 Honda CB 350K4, 74 Honda CB550
NEVER SNEAK UP ON A SLEEPING DOG..NOT EVEN YOUR OWN.
I would rather trust my bike to a "QUACK" that KNOWS how to fix it rather than a book worm that THINKS HE KNOWS how to fix it. -
http://webpages.charter.net/ddvrnr/GS850_1100_Emblems.jpg
Had 850G for 14 years. Now have GK since 2005.
GK at IndyMotoGP Suzuki Display... ... GK on GSResources Page ... ... Euro Trash Ego Machine .. ..3 mo'cykls.... update 2 mocykl
https://imgur.com/YTMtgq4Comment
Comment