ok so the bike before with stock ignition turned over fine but only was sparking 2/3 coil, now i installed the dyna s ignition setup but bike will not turn over, i can jump the solenoid across and it turns over with spark now though, but for some reason now the bike will not turn over by start switch? stumped...
-
-
-Mal
"The only reason for time is so that everything doesn't happen at once." - B. Banzai
___________
78 GS750E -
on or off does not turn overComment
-
what year 550?
What did you use for the mechcanical advance. What dyna s model (ones for different ignition supplier).Comment
-
dyna s ds3-2
1982 suzuki gs550
stock advanceComment
-
Is the rotor free to advance? When I installed mine the included spacer was too thick and would not allow the rotor to advance when the crank bolt was tightened down. I ended up sanding about 0.7mm off the top of the rotor and then it was free to advance. How did you set up your timing? My install, and others I have heard of, were very near the ends of the slots when the timing was right.
Comment
-
fitting a dyna s does not involve tampering with the starting circuit. you must have an issue elsewhere. try all the fuses for a start1978 GS1085.
Just remember, an opinion without 3.14 is just an onion!Comment
-
Info here on different ignition advancers...
Did your year have points? Or the sig generator?Comment
-
yeah all the fuses appeared to be good, i noticed there to be an extra plug in connector not plugged into anything but the only thing i did away with was the CDI which was the large green plug but close to it coming off the main wiring harness is a white 4 plug connector but only has 3 wires to it and its not plugged into anything, i dont remember if it was plugged into anything but i have nothing else it could plug into either thats the only thing not hooked up to somethingComment
-
what colour are the 3 wires in the plug?1978 GS1085.
Just remember, an opinion without 3.14 is just an onion!Comment
-
Good call, Agemax. When I see "turn over", I always think "start", since I've seen so many people say "it will crank but it won't turn over".
I think the connector you're talking about is the sig gen connector, which you also removed. How did you hook up the Dyna red wire?Comment
-
the power wire (red) i ran it straight up to the orange wires on the coil harness plugsComment
Comment