Accel Super Coils?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Spyder
    Forum Sage
    Past Site Supporter
    • Mar 2012
    • 3029
    • NW Indiana

    #1

    Accel Super Coils?

    I've been wanting to upgrade my coils for a while now. I've been doing research and have come to the conclusion that our choices are limited at best...

    I have used Accel Super Coils in MANY of my automotive builds.
    I have read a lot about all of you using Dyna Greens, at 3.0 ohms.
    I came across these Accel coils, but not sure if they will be a good choice or not @ .7 ohms...

    I know the lower the better for automotive, but these bikes are a bit more fragile that a car/truck.

    Any input? Have any of you used them? Will they do any damage?

    '83 GS 1100T
    The Jet


    sigpic
    '95 GSXR 750w
    The Rocket

    I'm sick of all these Irish stereotypes! When I finish my beer, I'm punching someone in the face ! ! !
  • slayer61

    #2
    Do your self a favor and do the research on this website... That being said, and all other things being equal- the ohmic value of your new coils MUST match your original OEM coils otherwise you will burn up an already fragile ignition system. Any of the coil manufacturers make coils with different levels of resistance for just this reason. I suppose if you really wanted to, you could use the Accel coils with .7 ohms, but you would have to use a 2.3 ohm ballast resistor in series with the coil to raise the resistance back up to 3.0 ohms... kinda defeats the purpose. Paul
    Last edited by Guest; 06-10-2013, 04:33 PM. Reason: add info

    Comment

    • Spyder
      Forum Sage
      Past Site Supporter
      • Mar 2012
      • 3029
      • NW Indiana

      #3
      THAT was my main concern. Thanks for the reply...
      '83 GS 1100T
      The Jet


      sigpic
      '95 GSXR 750w
      The Rocket

      I'm sick of all these Irish stereotypes! When I finish my beer, I'm punching someone in the face ! ! !

      Comment

      • Rover
        Forum Sage
        Past Site Supporter
        • Mar 2009
        • 1537
        • Central Mass.

        #4
        Accel does make coils with the proper ohm rating if you want Accels.
        http://i632.photobucket.com/albums/u...00080021-1.jpg
        1978 GS1000C
        1979 GS1000E
        1980 GS1000E
        2004 Roadstar

        Comment

        • SqDancerLynn1

          #5
          DO NOT use .7 ohm coils They are meant for a CDI ign and will over heat. You need 3 ohm coils regardless of what brand you buy

          Comment

          • Steel Toed Tank

            #6
            Accel super coils, 3.0 ohms, also currently the cheapest price on the internet.

            Comment

            • Spyder
              Forum Sage
              Past Site Supporter
              • Mar 2012
              • 3029
              • NW Indiana

              #7
              Thanks Tank. I was hoping to avoid the yellow wire thing, but some looming should cover that up well enough. Lol
              '83 GS 1100T
              The Jet


              sigpic
              '95 GSXR 750w
              The Rocket

              I'm sick of all these Irish stereotypes! When I finish my beer, I'm punching someone in the face ! ! !

              Comment

              • Agemax
                Forum Guru
                • Apr 2008
                • 8371
                • plymouth uk

                #8
                Originally posted by Spyder
                Thanks Tank. I was hoping to avoid the yellow wire thing, but some looming should cover that up well enough. Lol
                cover the HT wires with heat shrink tubing like i have. protects the wires, keeps moisture off and you can have them in what ever colour you like...
                1978 GS1085.

                Just remember, an opinion without 3.14 is just an onion!

                Comment

                • Steel Toed Tank

                  #9
                  Originally posted by Spyder
                  Thanks Tank. I was hoping to avoid the yellow wire thing, but some looming should cover that up well enough. Lol

                  The dyna greens with whichever wires you want run right around $175 at Z1.

                  It seems to me that almost all the drag bikes, many race bikes and tons of GSers run the dyna greens instead of accels.

                  And while both are going to be a big improvement over stock, I would get the greens myself.

                  Comment

                  • Spyder
                    Forum Sage
                    Past Site Supporter
                    • Mar 2012
                    • 3029
                    • NW Indiana

                    #10
                    Dyna greens are just an untested brand for me. Stick with what you know, ya know? I've been using accel products for decades and have only had a few go bad on me before their time. I know there are hundreds of bikes here with them with good results. Just a preference I guess.
                    '83 GS 1100T
                    The Jet


                    sigpic
                    '95 GSXR 750w
                    The Rocket

                    I'm sick of all these Irish stereotypes! When I finish my beer, I'm punching someone in the face ! ! !

                    Comment

                    • Steel Toed Tank

                      #11
                      Yeah I hear ya.
                      I have experience with neither so my judgement would be based on the many experiences I've read on here.

                      My plan for my coils is to replace then with a set off a late 90's gixxer.
                      I've seen 2 complete sets on ebay for under $50 shipped.

                      I think there is some kind of rule about putting shiny new parts on a dirty ugly rat bike, lol.

                      Comment

                      • Spyder
                        Forum Sage
                        Past Site Supporter
                        • Mar 2012
                        • 3029
                        • NW Indiana

                        #12
                        Nah! It's just one step closer to a clean shiny classic muscle bike!
                        '83 GS 1100T
                        The Jet


                        sigpic
                        '95 GSXR 750w
                        The Rocket

                        I'm sick of all these Irish stereotypes! When I finish my beer, I'm punching someone in the face ! ! !

                        Comment

                        • Steve
                          GS Whisperer
                          • Jun 2005
                          • 35924
                          • southwest oHIo

                          #13
                          Originally posted by Spyder
                          Thanks Tank. I was hoping to avoid the yellow wire thing, but some looming should cover that up well enough. Lol
                          You want to avoid yellow?

                          Just go to one of the side links in your original post:





                          .
                          sigpic
                          mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
                          hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
                          #1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
                          #2 son: 1980 GS1000G
                          Family Portrait
                          Siblings and Spouses
                          Mom's first ride
                          Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
                          (Click on my username in the upper-left corner for e-mail info.)

                          Comment

                          • Spyder
                            Forum Sage
                            Past Site Supporter
                            • Mar 2012
                            • 3029
                            • NW Indiana

                            #14
                            Will those work for me? Says they are for CDI. Just trying to be on the safe side. Don't want to cook anything.
                            '83 GS 1100T
                            The Jet


                            sigpic
                            '95 GSXR 750w
                            The Rocket

                            I'm sick of all these Irish stereotypes! When I finish my beer, I'm punching someone in the face ! ! !

                            Comment

                            • Steel Toed Tank

                              #15
                              Same ones, $163.

                              Comment

                              Working...