My ignition switch is failed, the key won't turn it. I had a locksmith out and I was able to remove the switch, but they cannot make a key for it that works. My bike is not in the best spot, and I want to 'hotwire' the connector, which two wires do I connect to start it? I sure hope someone can help me out!
-
-
join all 4 wires together and it will run1978 GS1085.
Just remember, an opinion without 3.14 is just an onion! -
Go to the fuse box, locate the MAIN fuse. Run a jumper wire from one of the legs over to the IGNITION fuse (probably right next to the MAIN fuse). Push the starter button, ride.
.sigpic
mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
#1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
#2 son: 1980 GS1000G
Family Portrait
Siblings and Spouses
Mom's first ride
Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
(Click on my username in the upper-left corner for e-mail info.)Comment
-
Thanks for the answers. It's funny, that on my way back to the bike, I thought about the switch and what it did, that it would not have a ground, it was just closing circuits. So I cut off the pigtail to the switch and connected all the ends and the light came on and I could start it right up. I just pulled it out when I got home.
Thanks again.Comment
Comment