Anybody ever measure SH-775 Quiesent current draw?

[tom203]

I'm assuming the draw will be low, but larger than the CF. A few mAmps perhaps but hopefully less than 10 mAmps

In case you missed it, my post -a few replies back- was refering to setup with the SH-775 .I measured draw of 1.5 mamps vanishing into harness most likely headed to SH-775

[posplayr]

In case you missed it, my post -a few replies back- was refering to setup with the SH-775 .I measured draw of 1.5 mamps vanishing into harness most likely headed to SH-775

Sorry Tom, I did miss that.

The 1.5 mAmps sounds about right and probably nothing much to worry about as for example the SSPB is about 2mAmps which is also nothing to worry about unless you want the bike to sit idle for 9 months.

If you pulled all of the fuses (except for main) then the R/R is probably all that is left. The most direct test is to measure the current on the R/R(-) leg to ground.

With all those fuses pulled, your idiot light box is probably not running , but mine measured about 0.5mA which is virtually inconsequential.