HELP !! Wanting GS1000S Wiring Harness

[Guest]

I have restored this Wes Cooley Replica but can't finish as my wiring harness is stuffed. The gauge cluster is the one without the clock and temperature gauge and the bike has electronic ignition. I don't know the exact model / year of the bike but believe a GS1000E (1980) wiring harness would work

Can anyone offer some help or point me in the right direction ?

Mark
Sydney Australia


IMG_1347.jpg

[Nessism]

I converted a 1000GL harness to work in my first 1000S. Someone had hacked the old harness by installing the early model hand control switches and a headlamp cut switch. At any rate, the swap wasn't too bad, I just had to make sure all the various circuits had the proper connections. Going off memory of several years ago but I remember removing the gear indicator circuits and adding the plugs for the fancy gauges like the oil temp. A large table is handy to spread out the harness so you can verify all the connections. High temperature Elliot tape was used to wrap the harness since it doesn't have any adhesive, you don't want to use electrical tape for that application.

Good luck.

[azr]

I'd have one to sell you but I'm in Canada so not sure if you want to pay the expected $75 or a bit more for the shipping alone.