I just got my dyna hooked up and installed but I?m kinda lost at the dyna directions, I know I need a timing light and to use the window to set everything while it?s running but where would I start as a rough estimate? The trigger plate turned all the way counterclockwise is full advanced right? Where is the tdc mark on the case? I see it on the rotor....any help would be greatly appreciated
-
-
There are three hold down screws located on the breaker plate. If you can not see a TDC line, TDC is located on the left edge, just touching the left edge, of the bolt head at the 12 o'clock position.
You need to start with the base place centered with the hold down bolt located at the 12 oclock position centered in the slot in the base plate.Last edited by earlfor; 10-16-2017, 07:47 PM.Komorebi-The light filtering through the trees.
I would rather sit on a pumpkin and have it all to myself than be crowded on a velvet cushion. H.D.T. -
Been a while since I messed with one on my 1100 but isn't there a red led on the unit that set the timing initially?Comment
-
When setting timing the light comes on simulating full advance. Using the mini degree wheel on the rotor set it to come at thirty-two degrees. I set mine at thirty-four degrees but I have the fuel to compensate. (jetting and high octane)Comment
Comment