(non)Charging system problem

[posplayr]

Should the stator wire go inside the tip of the clamp, or loose inside the clamp?

I'm not assuming anything about your question or your terminology and have therefore requested the part number or a link so I can confirm it will do what is required.

[Guest]

No part or link. Just a question on the procedure for measuring the current. Should the stator wire be pinched into the end of the clamp, or just be inside the clamp loosely.

[posplayr]

No part or link. Just a question on the procedure for measuring the current. Should the stator wire be pinched into the end of the clamp, or just be inside the clamp loosely.

I'm done with this thread.

[Guest]

Whatever.. You asked about the meter, I sent you the link. I asked for advice on the proper way to use it, you asked for a part number.

[Gorminrider]

the clamp meter goes around a single wire. (ie:you can't check your toaster's current without separating the two wires)

[Guest]

Thank you.