Although the bike has had little use it has been used and the fuel gauge has worked ok.
On a ride yesterday I noticed that fuel gauge was near zero and that matched what was in the tank so I put 8 litres in but the gauge did not move (or so I thought).
After a 1 hour ride I returned home and noticed that the gauge was showing a little under half full which is probably close to what it should show. However the gauge stays at that even with the sender disconnected and the two wires going to the gauge connected together which should give a full reading.
I am now thinking that the gauge must have a fault within itself or the "Fuel Gauge Regulator" which is shown on my wiring diagram has a fault.
I cannot even see the said Fuel Gauge Regulator after removing the back cover from the instrumwnts.
Anyone out there have words of widom to offer?
Comment