Three Dee Thread

[Lorenzo]

I was thinking about a thread where everyone can contribute with it's own experiences or the lack thereof

[Lorenzo]

Another addition/replacement of a tired component

1698968889831.jpg

[Lorenzo]

it will be particularly interesting given the fact, it's exposed to wear, tear and heat

1698968923105.jpg

[Lorenzo]

Another useful part

IMG_20231106_210744.jpg

[Lorenzo]

another pic of it

IMG_20231106_210809.jpg

[Lorenzo]

and where it's supposed to go

IMG_20231106_220520.jpg

[Lorenzo]

it will be particularly interesting given the fact, it's exposed to wear, tear and heat

1698968923105.jpg

This was definetely a fail.
No way TPU can stand the terminal temps, so, I'm thinking of something else (Hi-Temp filament seems to be too expensive, so not worth pursuing)

1700033986331.jpg

[Burque73]

Following along to see what you come up with next.

Didn't someone recently make some carb boots? I'm thinking they were to the airbox not the head.

[Lorenzo]

This very someone, managed to make both;

IMG_20230822_213520.jpg

[Lorenzo]

IMG_20230822_213556.jpg
Someone, somewhere in summertime

[Lorenzo]

IMG_20230814_102250.jpg Someone's knockin' at t he door

[Lorenzo]

Somebody's ringing the bell IMG_20230813_093809.jpg

[Lorenzo]

It's amazing how small a piece, even such a big printer can turn out;
the top part, where the little piece of paper is, Is hollow and just 1,2 mm

IMG_20231115_213006.jpg

[Lorenzo]

It top, has a place on the GS, and Is One of those parta that are frequently overlooked or patched up with sellotape

IMG_20231114_233025.jpg

[Lorenzo]

Yes, it's the rubber boot protecting the side panel tabs

IMG_20231114_232920.jpg