Breather tube blowing oil
Collapse
X
-
suzu650
Breather tube blowing oil
Have been working on my 83 Maxim 550 lately trying to get it rode worthy so I can sell it. Took it for a drive today and the motor got VERY hot. touched the oil cap and burnt my fingers. Also, Breather tube is blowing a little smoke and dripping oil (because motor is so hot). Whats my problem here? Has oil.
Tags: None -
7981GS -
JEEPRUSTY
Is yor tube routing back into the crancase via the airbox?
If not you need to put an appropriate filete on it as the crankcase will suck dirty air.
Natural for it to smoke if it just dangling.Comment
-
JEEPRUSTY -
Did you run it in the driveway without air flowing over the engine? Did you rejet the carbs to go along with the pod air filters?Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-ResurrectionComment
-
suzu650
Pod Filters have been on it since I have had it, and it has always ran fine before.
When idling when I first started it it idles fine. After I drove a few blocks when in nuetral idle would creep up and stay around 4000 rpms, and a few more blocks it was constant at 4000 rpms in nuetral. I was thinking this was the floats sticking, but from the sounds of it I could be wrong.Comment
-
7981GS
Comment
-
JEEPRUSTY
Comment
-
Floats sticking do not cause problems like that.Pod Filters have been on it since I have had it, and it has always ran fine before.
When idling when I first started it it idles fine. After I drove a few blocks when in nuetral idle would creep up and stay around 4000 rpms, and a few more blocks it was constant at 4000 rpms in nuetral. I was thinking this was the floats sticking, but from the sounds of it I could be wrong.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-ResurrectionComment
-
7981GS
Comment
-
JEEPRUSTY
Comment
-
7981GS
First off, how is the crankcase breather going to be SUCKING air?
Secondly, What language are you typing in???
How is anyone supposed to understand what you are typing???
DanielComment
-
Adler
He was saying that the breather tube should either route back to the air filter or have its own little filter. It shouldnt be open to unfiltered air.Comment
-
If it's running hotter than normal (and you say oil level is ok), maybe the oil pump ain't delivering oil to upper engine -plugged filter/bypass?1981 gs650L
"We are all born ignorant, but you have to work hard to stay stupid" Ben FranklinComment
-
dr_fosg8
If your idle is running up to 4000rpm at idle and this behavior is new and there is nothing you have changed it sounds like you have developed a vacuum leak on the intake. Cracked o-ring or intake boot not sure about a yammie.Comment

Comment