Winter projects. Heater?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Guest

    #16
    I use a unit called Farenheat baseboard heater, it's an older one (like from the 80's), but I'm always amazed on how well this hydronic baseboard unit works in the garage.

    Comment

    • Steve
      GS Whisperer
      • Jun 2005
      • 35924
      • southwest oHIo

      #17
      This is my heater:


      It's about 11,000 BTU and works well in my 2-car, semi-insulated garage.

      Uses just over a gallon of kerosene a day, if I leave it on full-time.

      Even if it's down to 10 degrees (F) outside, it maintains 55-60 degrees in the garage.

      It's also over 25 years old and still working well.

      .
      sigpic
      mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
      hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
      #1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
      #2 son: 1980 GS1000G
      Family Portrait
      Siblings and Spouses
      Mom's first ride
      Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
      (Click on my username in the upper-left corner for e-mail info.)

      Comment

      • chuck hahn
        Forum LongTimer
        Past Site Supporter
        • May 2009
        • 25918
        • Norman, Oklahoma

        #18
        Very low maintenance also..just trim the wick and replace once it gets to short. tech tip..dont use diesel in it like my buddy did his. It burns fine, but the deposits on the wick ruin it in short order.
        MY BIKES..1977 GS 750 B, 1978 GS 1000 C (X2)
        1978 GS 1000 E, 1979 GS 1000 S, 1973 Yamaha TX 750, 1977 Kawasaki KZ 650B1, 1975 Honda GL1000 Goldwing, 1983 CB 650SC Nighthawk, 1972 Honda CB 350K4, 74 Honda CB550

        NEVER SNEAK UP ON A SLEEPING DOG..NOT EVEN YOUR OWN.


        I would rather trust my bike to a "QUACK" that KNOWS how to fix it rather than a book worm that THINKS HE KNOWS how to fix it.

        Comment

        • cableguy

          #19
          Another version of Steve's. very steady heat, almost no fumes and quiet. Even though I don't have garage I bought one to bring to the garage I borrow for car repair, but I can't store it there. They're in Craigslist quite a bit here, I bet you pick one up for 50-75 bucks

          Comment

          • haztoys

            #20
            Originally posted by Steve
            This is my heater:


            It's about 11,000 BTU and works well in my 2-car, semi-insulated garage.

            Uses just over a gallon of kerosene a day, if I leave it on full-time.

            Even if it's down to 10 degrees (F) outside, it maintains 55-60 degrees in the garage.

            It's also over 25 years old and still working well.

            .
            I have one of these if you want it .. They do work good ...Its about 15 years old I dont use it any more ....

            Comment

            • Steve
              GS Whisperer
              • Jun 2005
              • 35924
              • southwest oHIo

              #21
              Originally posted by haztoys
              I have one of these if you want it .. They do work good ...Its about 15 years old I dont use it any more ....
              Thanks, but I already have two of them (bought them a year apart), don't really need another.

              No idea where you are, but shipping could be expensive.

              .
              sigpic
              mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
              hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
              #1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
              #2 son: 1980 GS1000G
              Family Portrait
              Siblings and Spouses
              Mom's first ride
              Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
              (Click on my username in the upper-left corner for e-mail info.)

              Comment

              • haztoys

                #22
                Originally posted by Steve
                Thanks, but I already have two of them (bought them a year apart), don't really need another.

                No idea where you are, but shipping could be expensive.

                .
                LOL ..That came out wrong ... I was offering to exzachtly1..

                Comment

                • trevor
                  Forum LongTimer
                  Past Site Supporter
                  • Oct 2011
                  • 18670
                  • Victoria bc

                  #23
                  Originally posted by haztoys
                  Yes and no ... The one burner does not heat anuff .. Find a two burner...
                  Yep I bought a two burner one and used it the other day..works great. I just leave the garage door open a bit so the wife doesn't freak out. I paid $50 on sale 1/2 price at good ole Canadian Tire.
                  No signature :(

                  Comment

                  • Steve
                    GS Whisperer
                    • Jun 2005
                    • 35924
                    • southwest oHIo

                    #24
                    Originally posted by haztoys
                    LOL ..That came out wrong ... I was offering to exzachtly1..
                    That's OK, we still don't know where you are and how bad the shipping would be.

                    How about updating your profile with a location? Does not have to be exact, after all, look how general my location is.

                    .
                    sigpic
                    mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
                    hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
                    #1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
                    #2 son: 1980 GS1000G
                    Family Portrait
                    Siblings and Spouses
                    Mom's first ride
                    Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
                    (Click on my username in the upper-left corner for e-mail info.)

                    Comment

                    • Guest

                      #25
                      I have one of the two burner propane tank heaters and it works great most of the time i only light one side run it on medium plenty warm in a 2 car garage it wont heat the whole garage but will keep the space your working around a bike nicely warm

                      Comment

                      • exzachtly1

                        #26
                        Originally posted by haztoys
                        LOL ..That came out wrong ... I was offering to exzachtly1..
                        Thanks for the offer! I think Steve is right that the shipping may be a lot, depending on where you are. Shoot me a PM or something. But right now I am probably leaning toward either the round tank-top ones or perhaps one of the "indoor use" kerosene or propane convection heaters. They are vertical cylindrical shaped, look nice and have good reviews for indoor use. About a hundred bucks; doesn't seem too shabby!

                        Comment

                        • Shwartz

                          #27
                          Originally posted by Steel Toed Tank
                          I heat up with this exact set-up.



                          Set up is very cheap, and fuel is free.
                          Very easily heats a 35'W x 40'L detached 2 car garage and keeps it toasty warm for hours with minimal effort.

                          http://www.northerntool.com/shop/too...ct_20894_20894

                          Electric heaters are no match for -40


                          Tank
                          If you can find a smaller version of this, the wood heat will suck the moisture right off the tools as opposed to electric.
                          I'm regrettably using electric this winter. We'll see how that goes.

                          Comment

                          • Steel Toed Tank

                            #28
                            Originally posted by Shwartz
                            If you can find a smaller version of this, the wood heat will suck the moisture right off the tools as opposed to electric.
                            I'm regrettably using electric this winter. We'll see how that goes.

                            Funny you should mention smaller!
                            The kit for this comes with everything but the barrel, so you can use what ever sized drum you want.
                            I used a big 45 gallon drum but then my garage doors offer zero insulation and minimal wind protection.

                            I can keep it hot as a summer day in there.


                            Tank

                            Comment

                            • chuck hahn
                              Forum LongTimer
                              Past Site Supporter
                              • May 2009
                              • 25918
                              • Norman, Oklahoma

                              #29
                              You can use some old blankets and hang them from the gargae ceiling and curtain off a section to trap the heat and youll have less of a space to overcome in the cold. Heat the space up quicker and save some fuel costs as well.
                              MY BIKES..1977 GS 750 B, 1978 GS 1000 C (X2)
                              1978 GS 1000 E, 1979 GS 1000 S, 1973 Yamaha TX 750, 1977 Kawasaki KZ 650B1, 1975 Honda GL1000 Goldwing, 1983 CB 650SC Nighthawk, 1972 Honda CB 350K4, 74 Honda CB550

                              NEVER SNEAK UP ON A SLEEPING DOG..NOT EVEN YOUR OWN.


                              I would rather trust my bike to a "QUACK" that KNOWS how to fix it rather than a book worm that THINKS HE KNOWS how to fix it.

                              Comment

                              • chuck hahn
                                Forum LongTimer
                                Past Site Supporter
                                • May 2009
                                • 25918
                                • Norman, Oklahoma

                                #30
                                Tank...check in with any local cabinet makers or contractors and ask them if you can gather thier scrap ends and such..good sources of free fuel for that stove.
                                MY BIKES..1977 GS 750 B, 1978 GS 1000 C (X2)
                                1978 GS 1000 E, 1979 GS 1000 S, 1973 Yamaha TX 750, 1977 Kawasaki KZ 650B1, 1975 Honda GL1000 Goldwing, 1983 CB 650SC Nighthawk, 1972 Honda CB 350K4, 74 Honda CB550

                                NEVER SNEAK UP ON A SLEEPING DOG..NOT EVEN YOUR OWN.


                                I would rather trust my bike to a "QUACK" that KNOWS how to fix it rather than a book worm that THINKS HE KNOWS how to fix it.

                                Comment

                                Working...