I'm doing a 530 chain conversion, new sprockets and wheel bearings, all parts from Z1.
I put the rear wheel back on and I've got a too much room/play, even if I tighten the axle nut all the way past the threads, I've still got too much space. It's like i'm missing a spacer or I put it back together wrong, I checked the fiche and took 'before' pictures to help me remember, but I guess not good enough.
What am I missing or assemble wrong?
Here's the left and right side of the wheel:
I seated the bearings all the way down, not flush, but even if they were flush, there would still be slack. My #4 is inside the middle of the wheel between both bearings, my #5 is inside the sprocket drum like what the fiche seems to show.
I put the rear wheel back on and I've got a too much room/play, even if I tighten the axle nut all the way past the threads, I've still got too much space. It's like i'm missing a spacer or I put it back together wrong, I checked the fiche and took 'before' pictures to help me remember, but I guess not good enough.
What am I missing or assemble wrong?
Here's the left and right side of the wheel:
I seated the bearings all the way down, not flush, but even if they were flush, there would still be slack. My #4 is inside the middle of the wheel between both bearings, my #5 is inside the sprocket drum like what the fiche seems to show.
Comment