.png "Powered by vBulletin")
I need to remove the turn signals from an old bent bracket and install them on my new old brackets, but I can't get the nuts off. I can't figure out how to access whatever is inside the plastic housing that is holding the threaded end. Any tips?
-
-
The spares I have here seem to have the threaded tube molded into the plastic housing. They don't move. The threaded tube is turning on yours?Dogma
--
O LORD, be gracious to me; heal me, for I have sinned against you! - David
Skeptical scrutiny is the means, in both science and religion, by which deep insights can be winnowed from deep nonsense. - Carl Sagan
--
'80 GS850 GLT
'80 GS1000 GT
'01 ZRX1200R
How to get a "What's New" feed without the Vortex, and without permanently quitting the Vortex -
Ok, thanks.
The threaded tube turns inside the plastic housing, about 1/4 turn, then hits against something inside. Maybe it's broken? I might try demangling the old headlight brackets...Comment
-
If they are like mine a pair of channel locks holds the plate then turn nut.Comment
Comment