I had a small oil leak somewhere on the top of the cylinder / cylinder head (its kinda hard to tell exactly which is why Im posting this). So I replaced the valve cover gasket, adjusted the valves, retorqued the head bolts, cleaned it all up and lo-and -behold, its still leaking (even though the old gasket fell apart upon removal). So are the some type of crush washers or O-rings that I should've replaced ?
-
-
Pull up the parts fiche for the "cylinder head" and you'll see two O-rings (#17) that seal that tower looking seal nut (#14)... that's a common leak area.
http://www.boulevardsuzuki.com/fiche_select.asp -
82 1100 EZ (red)
"You co-opting words of KV only thickens the scent of your BS. A thief and a putter-on of airs most foul. " JEEPRUSTYComment
-
You guys rock. I may pull it apart this weekend and replace them.Last edited by TxGSrider; 08-25-2016, 08:34 PM.1982 GS1100E "Jolene"Comment
-
I pulled the cover and changed the o rings. One had obviously been leaking. Thanks guys for your help.1982 GS1100E "Jolene"Comment
-
I wonder if that is where my leak is coming from now. It's right there in the middle as well.Comment
Comment