GS 1150 Cylinder Bore Specs

**Gerry** · 09-19-2005, 05:48 PM

My book says for the 84 gs 1150 the bore is 74.00 mm (2.913 in)

This is a link to the scanned page out of my book but i don't think you can make out the numbers

http://i3.photobucket.com/albums/y53/gerbis/Untitled-Scanned-01.jpg

Hope this helps, Gerry

**mike J** · 09-20-2005, 08:10 AM

Thanks Gerry, I guess I should have been more specific, I need the factory service limits for the cylinder bores. I would also like to have the factory ring service limits too. Thanks again. Mike J

**Gerry** · 09-20-2005, 05:41 PM

Hey Mike,

Here are a couple more pages that might help you.

CYLINDER BORE

PISTON RINGS

Gerry

**mike J** · 09-20-2005, 05:44 PM

Thanks Gerry, that's exactly what I needed, you rock!!! Mike J

**mike J** · 09-20-2005, 06:00 PM

Gerry, One more question, it looks like your Dyno sheets says that you 38mm flat slides on your bike, do they run good for street riding? Mike J

**Gerry** · 09-20-2005, 07:37 PM

Mike,

I had a guy set them up and he did a great job. They seem to make the bike a little jumpy at low rpms but it's not a problem. Other than that small detail they've run great for the last 5 or 6 years.

Gerry

GS 1150 Cylinder Bore Specs

GS 1150 Cylinder Bore Specs

Comment

Comment

Comment

Comment

Comment

Comment