can i use 2.2 ohm coils on point sytem
Collapse
X
-
Yeap a points system will work with no problems.1166cc 1/8 ET 6.09@111.88
1166cc on NOS, 1/8 ET 5.70@122.85
1395cc 1/8 ET 6.0051@114.39
1395cc on NOS, 1/8 ET 5.71@113.98 "With a broken wrist pin too"
01 Sporty 1/8 ET 7.70@92.28, 1/4 ET 12.03@111.82 -
5 ohm coils are spec'd for points ignition systems. It would probably be OK if you wanted to parallel wire a 2.5 ohm resistor to each 2.2 ohm coil. Although, I think its a better idea to just use what is supposed to be used.
Earl
Originally posted by odl777can i use 2.2 ohm coils on point sytem, i would really like to put these coils to use and for some reason i have thought i read that you have to do something special to make then work thanksKomorebi-The light filtering through the trees.
I would rather sit on a pumpkin and have it all to myself than be crowded on a velvet cushion. H.D.T.Comment
-
Boondocks
Yesterday jeff.saunders of Z1 Enterprises answered your question in his post at Which Coils Work With Points?. His reply states that 2.2 ohm coils should not be used with a points system and resistance should be matched the specs for the bike.Originally posted by odl777can i use 2.2 ohm coils on point sytem, i would really like to put these coils to use and for some reason i have thought i read that you have to do something special to make then work thanksComment
-
I've tried to tell you in your past posts....don't use 2.2 ohm coils on your bike.And on the seventh day,after resting from all that he had done,God went for a ride on his GS!
Upon seeing that it was good, he went out again on his ZX14! But just a little bit faster!
Comment
-
the only reason i want to use them is because they are all i have. Also i have heard that many coils measure high resistants than what they are suposed too. Like say some 3 ohm coils sometimes are actually 4ohm. Thanks any other suggestions will be helpfull.Comment
-
OK. But sometimes you have to use the correct parts. I don't want to see you damaging/burning up parts.Originally posted by odl777the only reason i want to use them is because they are all i have. Also i have heard that many coils measure high resistants than what they are suposed too. Like say some 3 ohm coils sometimes are actually 4ohm. Thanks any other suggestions will be helpfull.And on the seventh day,after resting from all that he had done,God went for a ride on his GS!
Upon seeing that it was good, he went out again on his ZX14! But just a little bit faster!
Comment
Comment