Time for some work

[rustybronco]

What do you all use for assembly lube? My local supplier did not have molybdenum disulfide assembly lube, but they did have a different moly lube by Sta-Lube. Will that work?

should work on the cam lobes and valve stem and tips just fine, don't go "hog" wild.
oil the cam journals, crank it (w/o spark) till oil gets to the top end, then fire it up.

[condensr]

Well, making a little progress.. Pistons cleaned, clutch cover off (gasket replacement)..

Tomorrow I hope to get the oil pan off (cleaning of pan/screen) and flush the open bottom end (from the top - jugs are still off) with some kero then some oil. Try as I might, I couldn't keep 100% of the debris collected around things like the head studs from dropping down in to the engine during disassembly.

Then the re-assembly starts! Hopefully I get time to work on it so it doesn't drag out too long.