to first introduce my bike, I have a 1982 gs 650, done lotssa work to it but when it comes to wiring i am completly lost. to sum up my problem quickly, i was putting in a new wiring harness adn when tryin to disconect my R/H molex connector the male part of the connecter ripped adn stripped the wires from the connecter, now iv gotten a new R/H switch assembly froma 1981 gs 550, the connecter from that one only has the 3 wires to plug in like the origiaonal but now i have 6 wires that i dont know what to do with, with the origional male connecter ther were a few wires conecting the 6 wires to each other but now i dont know which connects where and im thinkin this is the reason y my bike wont start now
-
-
Match up the wires and bypass the connector. -
the problem with it is ther are 6 wires coming out the back end of the connecter adn i dont know hwat the do i tinkered with a few of em and when i connected the 2 middle ones together the back-lighting for my speedometeer came back onComment
-
im just hopin that somone can atake a picture of how theirs conects adn i can just match it up that wayComment
-
Are you talking about the right hand handle bar switch that connects in the headlight bucket?Comment
-
no it conects and stays by the gas tank its the kill swithc adn starter wires the kill swith'starter wired match up with colorwise with the way i have thme pluged in right now, but the other 6 wires connect to each other by just loopin one wire to another im just not sure witch one to hook up to wher, 3 of the wires go into the headlight bucket while the other 3 go down towards the batteryComment
Comment