I had to change out my Windjammer V fairing and rear turn signals and now they won't flash. I was reading up on the Turn Signal Load Equalizers but really can't tell if that is my problem or what. I assume it had something to do with the different ampere ratings of the OEM's and the new smaller incandescent bulbs, and I am sure it wasn't just coincidental that when I took those two things off the signal generator went bad. I was looking at the "Kuryakyn Load Equalizer for Electronic Flasher Units" on DennisKirk.com and was wondering if anyone else had this problem or recommended what to do.
-
-
Did your bike have a PO who messed with the wiring? -
What do you mean PO? I am a little new to all this.Comment
-
did you use LED's or some such type ?? You would need an electronic flasherComment
-
PO = Previous owner.
Can't help you with your problem because I didn't do the wiring.Comment
-
Done
Yeah, it was that Load Equalizer I was talking about. I didn't use LED's but I did use smaller incandescent bulbs that didn't draw as much. I used the Krukayan(or whatever) 4 Ohm equalizer. It's mounted right underneath the seat. it works great now. Thanks for all the replies.Comment
Comment