Anyone know how to remove the pins that are holding the floats on on 33 smooth bores?
-
-
I use a drift punch & a SMALL ball pein hammer to tap them out. Tap LIGHTLY to get them loose so you don't break the pin posts. If you break the post you are semi-screwed! Ray. -
Ok, Great, thanks.. Also does anyone know at what height the floats should be set?Comment
-
I don't like to use a punch since the post may break off. If possible, use a small screwdriver and lay the blade along the edge of the post and try to catch the edge of the float pin head. If you can catch the edge you can twist the screwdriver to pry the pin loose. Much less risk of busting the post.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-ResurrectionComment
-
Thank you for the tip!Comment
Comment