I had the bolts shear off on the starter clutch. I pulled it apart and fixed the clutch, but now the bike will barely turn over. I did have to use a different intermediate gear, but I turned the motor manually to test it. Any ideas would be great. Thanks
-
-
The only obvious question is what intermediate gear did you fit? 'New' intermediate cog has different teeth or size? Starter not engaging intermediate cog when you use the electrics?
Why did you have to change it when the starter clutch went wrong?
I would have expected that if you changed like for like there would be no problem.
Suzuki mad -
I had to change it because the toolbox I left it in was stolen...but the replacement seemed to fit perfectly.Comment
-
is the rotor bolt tight enough?2002 bmw r1150gs 1978 gs1000E skunk les pew 1982 GS1100
1980 gs1000G the ugly RLAMComment
-
Its Suzuki mad mad question time.....
Whats the battery like? Fully charged up? My GS always spin slow when the battery tenderiser hasn't been on while she sat in the garage a few days.
Suzuki mad.Comment
-
I am assuming that you used the correct gasket ?? Remove the starter & wiggle the idler gear. Was the gear out of the same size motor ?Comment
Comment