Looked for but didnt find...

[Guest]

in the carb stickys anywhere a base setting for the fuel screws on a 77 750 with a 4into1 and pods?? Anyone got an idea??


Thanks!!

[Dave8338]

I'd start with 1 1/2 out from lightly set and work from there.

[Nessism]

You are going to need a jet kit, the pods and exhaust will lean the mixture.

Your carbs have two adjustments: pilot fuel screw and pilot air screw. Standard setting is approx. 3/4 -1 turn for the fuel screws and 1-1/2 for the air screw. Adjust the air screw to give the highest idle speed. Adjust the fuel screw to get the best off idle transition to the pilot circuit.

[TheCafeKid]

You are going to need a jet kit, the pods and exhaust will lean the mixture.

Your carbs have two adjustments: pilot fuel screw and pilot air screw. Standard setting is approx. 3/4 -1 turn for the fuel screws and 1-1/2 for the air screw. Adjust the air screw to give the highest idle speed. Adjust the fuel screw to get the best off idle transition to the pilot circuit.

Yeah i know...doan need a jet kit...Im not lean, actually im very rich...air screws adjusted to 1 1/2 need to back off the fuel screws... Problem is that when Steve and i synched the carbs and adjusted the air screws we found the air screws were all over the place...none of them were the same, so am assuming that my fuel mix is the same...just need a baseline..