Where can i find the halfmoon plugs...

[TheCafeKid]

that go on the valve cover/tray ends? Using a bit of teflon tape now, but want to replace them all eventually...

THanks!!
TCK

[Guest]

Look under cylinder head part #18 here

[TheCafeKid]

Good one that!! Thanks man!!

[salty_monk]

I use http://www.flatoutmotorcycles.com/

Cheaper than www.bikebandit.com

Dan

[Guest]

Or you can get some aluminum ones:

http://cgi.ebay.co.uk/VALVE-COVER-SEAL-FOR-MOST-SUZUKI-GS-GSX-EARLY-KATANA_W0QQitemZ140166807468QQihZ004QQcategoryZ10534QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

[79-GS550-L]

I got a set of the aluminum ones... they have a lip on both sides, mine would not fit until I ground off the inside lip with a dremel. Then they fit perfectly. Unfortunately two are leaking (very slightly) but I think that's my fault. I used black RTV on them, I am thinking of replacing that with JB weld or something next time I do my valves.

[TheCafeKid]

Well i had a decent leak in one after doing the valve adjustment, but i took steves advice and used some teflon tape on it, worked like a charm. And thanks to chef i found new ones..they'll be goin in this winter for sure..:-D

[Suzuki_Don]

ULTRA BLUE also works a treat under the seals.