Ok, here we go. I removed the tank, drained and cleaned, will breakdown petcock tommorrow. Performed compression check, #1=160 #2=175 #3=160 #4=175. That made me happy. Spark check was next. #1 and #4 showed no spark and #2 and#3 had spark. I always use a multi-meter to ensure accurate readings. Now, if it had been 1 and 3 or 2 and 4 no spark I would say coil and that would be easy but with one leg out on each coil I lean towards a component like igniter. I looked for a part photo but no luck. I even only see it in schematics and not prints. How do I recognize this part or should my attention be elsewhere.
-
-
well I have good news, 1&4 are on the same coil and 2&3 share a coil so your problem may be a bad coil or bad power or control (AKA ground) connection to the coil.
then again it could be a bad igniter also but you want to check continuity's first before changing parts. -
Ok, I have an old set of accels off my 78 gs 1000 parts bike. See ya tomm.Comment
-
It was my bad, kz was 1234 left to right. The book I just looked at shows 1423 as you look down on coils. Is this correct? That means I have no spark on 1 and 3.Comment
-
Ok, got it. I'll post back tonight.Comment
-
Switched coils, still no spark 1 and 4. Going for pick up coils in side cover by ignition but tomm night. any other suggestions ? Starting new post "82 1100 glz no spark 1&4"Last edited by Guest; 10-23-2007, 07:16 PM.Comment
Comment