Fitting a steering damper.

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • spyug
    • Feb 2026
    #1

    Fitting a steering damper.

    My good buddy Dee (Kingof Venus)has come through again and I now have a steering damper to bolt on the old Blackbooty. Many thanks Dee once again.

    I think I know where to mount it as there a couple of bolts welded to the frame down rails on either side but I have a question or two.

    Which side is best? I think it could go either side but is there a preferred side?

    Does the damper rod and fork clamp need to run and attach in a straight line which would mean the damper will bolt to the frame at a bit of an up angle?

    When the damper rod is fixed to the clamp can it have a bit of play in it (at the clamp) or does it need a tight fit. I assume the clamp needs to be tight on the fork leg however.

    When the damper is fixed in place what setting is usually preferred, firm soft or in between? How do you go about determining what is best?

    Anyone have a pic of a damper fitted to an 83 or later bike?

    Any thoughts or suggestions?

    As always, I appreciate all input.

    Cheers all,
    Spyug
    Tags: None
    • Junkie
      #2
      Why do you want one, are you getting headshake in some situations or something?

        Comment

        • spyug
          #3
          No real or pressing need to add a damper but I like to fiddle and its a small project. I promised the wife I wouldn't do another full bike build this winter

          I haven't experienced headshake personally but I've seen vids (there's a fairly famous one from the Isle of Man TT) and I wouldn't like to be on the receiving end of one.

          I've also been thinking about doing some track days this year and I was reading how some guys set up their bikes and a damper is recommended.

          Have you any experience with them?

          Cheers,
          spyug

            Comment

            • Griffin
              Forum LongTimer
              Past Site Supporter
              • Sep 2003
              • 14205
              • Danville, IN
              #4
              My '83 XJ750 Seca came from the factory with a steering damper. This bike's overall layout is very similar to your GS's.

              I'll take some pics tomorrow of how it's laid out to give you some ideas.
              GS450E GS650E GS700ES GS1000E GS1000G GS1100G GS1100E
              KZ550A KZ700A GPZ750
              CB400T CB900F
              XJ750R

                Comment

                • TheCafeKid
                  #5
                  Most of the guys who've installed them on the cafe forums ive read about seem to have a good idea of installing them on the left side of the bike (when on it) as if you have to adjust it while moving, you dont have to take your hand off the throttle.

                    Comment

                    • 80GS1000
                      #6
                      Craig Smithy over on OSS has one fitted on his GS1000 racebike, maybe shoot him a PM. I have one too as the K4 GSXR 1000 forks came with one standard on that front end. I just had to weld a bracket to the headstock to get it to work.

                      Craigs setup:

                        Comment

                        • kichigai
                          #7
                          Post up if you get one installed and let us know how it works out since I wouldnt mind installing one on my Gs1100esd too!

                            Comment

                            Previous template Next
                            Working...