.png "Powered by vBulletin")
Anyone know what size allen wrench I need for this?? Nothin I have seems to fit the small inner hole and I sure dont have one large enough for the entry hole....
-
-
I don't know what sort of "pivot shaft" you're working on, but will assume first (also guessing that it's on a Suzuki bike) that it's metric and offer the following. If you have only SAE inch measurement allen wrenches, split the difference to find the small size (between the go-no go size....go to nearest metric size). For the larger size you can use common metric hex-head cap screws to gauge the size needed (use the hex head.....either as a gauge.....or sometimes a wrench can be made out of same).Originally posted by mortation View Post
Some ball park sizes would help me assist you more.......metric allen wrenches are pretty cheap and are a good gauge - even if you end up then buying a square drive "bit" to put some real torque into the job. -
"Pivot shaft", where? What bike?
EarlKomorebi-The light filtering through the trees.
I would rather sit on a pumpkin and have it all to myself than be crowded on a velvet cushion. H.D.T.Comment
-
Sorry guys was getting tired nd frustrated. I got it
It was the pivot shafts holding the swing arm on. Thanks.
Comment
Comment