Where do you apply dialectic grease?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • KEITH KRAUSE
    Forum Guru
    Charter Member
    GSResource Superstar
    Past Site Supporter
    • Oct 2002
    • 8862
    • Angeles Forest, So.Calif./Red rocks of Southern Utah.

    #16
    On a tube/sleeve connector, I fill the opening with grease and connect the wires. With female/male ends, I coat both.
    If a ring terminal too, I coat the surface with grease.
    You don't need a lot but get full coverage.
    And on the seventh day,after resting from all that he had done,God went for a ride on his GS!
    Upon seeing that it was good, he went out again on his ZX14! But just a little bit faster!

    Comment

    • J_C

      #17
      Thanks for the response Keith!

      Comment

      Working...