4 wires on the plug (4 prong plug):
- Light Green (controls the rear, front and gauge indicator for the right side of the bike)
-Black (controls the rear, front and gauge indicator for the left side of the bike)
-Light Green/Black (goes to the turn signal switch on the right side)
-Black/Blue (goes to the turn signal switch on the left side)
Orange to Orange/Red is the power supply to not only the blinkers but also the headlamp for the front of the bike.
So, when wiring it as described above, all three (plus the back) blink in unison as if I had hazard lights stuck on.
The only way I see around this (without buying the part) is to connect 2 toggle switches- one with a left, middle and right position and another with a left/right position. The first will control the blinkers and the second will control the power going to and from the flasher (so that it is not continually on).
Do you (or anyone) see another option, or where I made a mistake?
j razz
Comment