Hi I just got a new parts bike I'm trying to get to run right. It runs but I think the PO doinked with the carbs. If he applied the same skill set as he did to gapping the plugs to 0.045" then I got problems.

Anyway, I pulled the carbs apart, spray cleaned then, removed varnish and hoped for the best on the float height. Anyway it seems it is off as #4 is flowing over .

Anyone know what the float height should be and point me where to look on setting the level. I have two manual coming from Flea bay but just ordered them yesterday.

OK some pics for motivation






Thanks

Posplayr