i have a 1981 gs1000g. I have a new tach gear, but i can't figure out how the assy comes apart. i looked at the drawing at bikebandit.com, but i couldn't tell how it comes apart. any one know how it comes apart? machined fit? threads? help!
-
-
on the wheel or the tach itself? -
tach gear
The tach worm gear assy that is mounted in the head under the valve cover. The tach cable screw mounts into it.Comment
-
On the fitting that the cable end screws into(on valve cover) there's a tab, with a screw thru it that goes into the valve cover, after you pull the screw and remove the tab, the fitting with gear will pull out, note thrust washer below gear!!!Comment
-
Tach Gear
Also while you have it apart, spend the eight bucks for the two seals. One is a flat faced o-ring that goes around the housing and the other is a press in seal for the tach gear shaft. It'll keep the garage floor neat!1982 GS1100GLZ Sold but still loved
2008 Bandit 1250 Crashed (cager on a cell phone)
2008 Bandit 1250 #2Comment
Comment