RR - how to tell what are the output connections

[Guest]

this is a follow up to my thread about a dried-up battery

http://www.thegsresources.com/_forum/showthread.php?p=886387&posted=1#post886387

i am not too sure if my rr has been connected properly (it is supposedly an rr used on kawasakis)
i know that 3 pins are the input for the stator wires

is there a way to tell (test) which output pin is which (i.e. negative, positive, sense)?

[Guest]

all good

i was able to find a wiring diagram for this rr and confirm what each of the connections is

[Steve]

Care to share?

I looked in a couple of places this morning when I saw your post, and saw that you were asking on other forums, too.
Where did you find the information?

.

[Guest]

it's an italian catalogue of electrical components

http://www.sgr-it.com/download/pdf/16e_volani_alternatori.pdf

page 59 onwards lists replacement regulators
the bottom of each section tells you the oem part equivalent

greetings from down under

[Steve]

Yep, right there it is, on the top of page 64.

I have bookmarked that site. I have a device at home that I bought on eBay as a replacement for my wife's r/r. It was labelled as a Gold Wing unit, but I could not get it to work. I am not sure if it is one of the early units that is only a rectifier, or maybe I connected to the wrong terminals. With this site I will be able to check it when I get home in a couple of weeks.

Oh yeah, Greetings.

[Guest]

im glad the info was helpful