gsx 1100 oil leaks

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • sebroodryk

    #1

    gsx 1100 oil leaks

    My `81 gsx 1100 ex, is blowing oil out at the brather when i go over 80 mils an hour, and it all goes on the raer wheel, what must i do to stop it and i cant get any filter that needs to go in at the braether. Can any one help me here.
  • SqDancerLynn1

    #2
    The breather hose should connect to the air box. If you have pods you should have a filter connected to the end of the hose-installed at upwards angle so anything will drain back into the engine.
    Have you checked the oil level ? If the petcock is bad it could allow gas to get into the crankcase overfilling it causing lots of problems including blowing oil out the breather

    Comment

    • rapidray
      Forum Guru
      GSResource Superstar
      • Oct 2006
      • 8195
      • So Cal

      #3
      You may also want to do a compression test & leak down test if you find the crankcase is NOT over filled. Ray.

      Comment

      • sebroodryk

        #4
        Hi, well i dont have the origenal carbs on and no air box, i got mikuni carbs on " slaids " Do you think it is sump compression ?

        Comment

        • sebroodryk

          #5
          Hi there the engen isn't over filled with oil it is exactly on the full mark on the glass view. Do you think its sump compression ? And the engen is not leaking any oil any where ells

          Comment

          • rapidray
            Forum Guru
            GSResource Superstar
            • Oct 2006
            • 8195
            • So Cal

            #6
            If it is NOT over filled then I'll bet money the rings are tired & the oil is getting pushed out because of "blow by". "Blow by" is a condition created when the rings loose tension & allow compession to "blow by" them & pressurize the crankcase & push oil out the breather. To fix it requires a cylinder hone & re-ring. You need to do a leakdown test to see if that is the issue. Ray.

            Comment

            • feelergaugephil

              #7
              PM sent.............

              Comment

              Working...