crank seals in backwards...
rookie mistake
rookie mistake
-
-
Hey Bruce, DON'T sweat it! I know it was wrong because I did it wrong once too! Ray.Comment
-
when the seal is installed correctly...it looks like its backwards.
i almost did it years ago but i popped off an ign. cover from a differant bike and seen how it went.
the little blocks(feet) on the crank side of the seal sits against the main bearing.
if suzuki had put an arrow of rotation or marked the seal (out) or something..this wouldnt happen.
once a person installs one the wrong way...
well, they never let that happen again.Comment
-
It's only a "mistake" if you do something wrong TWICE.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-ResurrectionComment
But it sure doesn't help when the drawing you are going by is wrong!
Comment