crankcase oil seal 2

[tlg1100]

what steps do you take to get ingnition out of the way dont have repair book right now thank for any help gs 1100 1981

[Guest]

Remove three screws on ignition plate. Remove the 12mm bolt at the end of the crank trigger. Pull it all out. The advance can be a bear sometimes to get off the crank.

[tlg1100]

thanks

do i have to worry about timing has dyno electronic ing.

[Guest]

If it is timed now and running good mark the Dyna and crank case so you can install it at the same timing.

[tlg1100]

thanks chef

done it alomg time ago on old kaw was not not sure