gs1000 hydraulic clutch

[Agemax]

How about a rear master cylinder along with a bellcrank of some sort to convert the pushrod into a pulling device to replace the cable?

good point, i have looked into that as well but its how to mount it on the crankcases. i got a local supplier from work looking into a hydraulic cylinder that will screw into the origonal threads of the clutch cable

[rphillips]

If you turn the actuator arm arount, then it will need to be pushed instead of pulled.

[Agemax]

If you turn the actuator arm arount, then it will need to be pushed instead of pulled.

true but you need to mount a cylinder to push it, which is tricky

[Homie]

Loved the hydraulic clutch on my Big Bandito, so this is something that I have been thinking about. It's been two years since the last post on this thread. Have any of you guys who posted on this thread back then had any luck with making this mod? Or did it prove too difficult and was abandoned because it presented too many technical problems to overcome at a cost effective price?

[Agemax]

more trouble than its worth, so i just went for the window clutch cover instead

[Homie]

more trouble than its worth, so i just went for the window clutch cover instead

That's kind of what I figured since the thread just died out without a triumphant post of sucess. Curious about the "window clutch cover" though - what is that??

[Agemax]

youve never seen a window clutch?

http://i188.photobucket.com/albums/z260/agemax/100_1025.jpg

[JEEPRUSTY]

http://forum.oldskoolsuzuki.info/cgi-bin/Yabb/YaBB.pl?num=1308135663

???

[7981GS]

I have a spare clutch M/C if someone Stateside is interested in doing this.
I am not myself.

Daniel

[Guest]

Slave ??

Is this what WE all need? It's a Pull type slve and from my calculations, is perfect and gives the correct leverage with the stock length lever on the clutch cover. I think to mount it to the left side upper motor mount plate and pull across the engine. Thoughts?
G