i just got a set of carbs and i think the po put the bushings in the wrong holes, they are in the pilot circuits. Should this be or should it be the main air circuit?
-
-
bumpity bump -
looking at the intake side of the carb... you should see two holes to the sides in the middle. the one on the left that has a flat head screw driver slot is not it. On the right side there should be a hole with something in there with no visable means to get it out.. thats the hole. Use the supplied air restictor driver to put it in place and then dab a little of the supplied glue around the edge... avoid getting any glue in the hole.
hope this helps, good luck with itComment
-
lol they put it in the wrong hole, now i have to try and get it outComment
-
woo hooo the po did put it in the pilot air jet. So with a small self tapping sheet metal screw and a slide hammer they all came out. Then i used a center punch to reinstall then(the point kept it center and from mushrooming) EASY PEESY!!Comment
-
So much for pictures in the Dynojet directions.
Comment
-
lol so much for directions period. Im guessing the special tool is a punch with a nipple that goes in the bushing to keep it from mushrooming. Well mine look like they were just hit in with a hammer and no punchComment
Comment