First time carb syncher requesting tips.

[woodsietx]

I've got the fan covered. The bro-in-law has a rather large one in the garage for dog cooling. I could even use the cooling tower he bought.

I looked at the adjusters and planned to give them a spray of something, probably WD40.

Check the sync one last time after tightnening the lock screws. A small nudge can throw it all off.

Thanks for the reminder. I learned that doing the valves. Check, tighten, re-check, loosen, check and tighten again, etc ...

Here's my checklist of everything I did that may affect fuel settings:

Cleaned out tank.
New petcock.
New fuel line.
Rebuilt carbs.
New plugs.
Adjusted valves.
Changed oil.
New choke cable (pending).
Purchased CarbTune.
Purchased carb adjusting tool.
Rebuilt tach (pending).

Anything I missed?

I haven't done the electrical system test but that should not affect fuel delivery once it's running?

I hope to have everything fall into place this Saturday. (Dare I hope to ride on Sunday?)

BTW, they sold all the puppies. I get to work inside again.

Y'all are awesome for all the advice. Thanks.

Woodsie