gs1100E wiring

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • mudy851

    #1

    gs1100E wiring

    looking for info on wirring diagram to find out where two grounds on my harness go to any help would greatly be taken THANKS
  • rapidray
    Forum Guru
    GSResource Superstar
    • Oct 2006
    • 8195
    • So Cal

    #2
    WHICH grounds you are referring to or PICTURES would be a LOT more help! Ray.

    Comment

    • Baatfam
      Forum LongTimer
      Past Site Supporter
      Super Site Supporter
      • Jul 2006
      • 18751
      • Knoxville, TN

      #3
      Also, what year GS1100E?
      We can help you friend, we just need a little more info...
      Bob T. ~~ Play the GSR weekly photo game: Pic of Week Game
      '83 GS1100E ~ '24 Triumph Speed 400 ~ '01 TRIUMPH TT600 ~ '67 HONDA CUB

      Comment

      • almarconi

        #4
        Ray don't you know which grounds The black wires on the harness

        Comment

        • Guest

          #5
          Originally posted by mudy851
          looking for info on wirring diagram to find out where two grounds on my harness go to any help would greatly be taken THANKS

          Is everything working as it should? If so tuck em away and forget about it.
          If not then ground em and whatever aint working prolly will.

          How bout that!

          Comment

          • Guest

            #6
            The two I know for sure on your bike will be
            One on the battery box
            The battery to the upper engine case.

            Comment

            • TheCafeKid

              #7
              From memory, MOST GSs (and Ive recently been in the guts of TWO GS1100E wiring harnesses, an 82 and 83) have a ground in the headlamp (or really a couple of them for the turn signals) one attached to the bottom of the lower yoke clamp (also where the brake line splitter bolts up to) then further down the harness, one should go to your battery, and one should be bolted to the frame somewhere nearby. Really it doesnt matter WHERE you bolt them, so long at they are attached cleanly to the frame at some point and provide a good connection to ground. The motor ground is a LARGE BLACK wire that comes from the top of your trany half case to your battery. All black wires with a white stripe are ground. There are also a couple of black wires with white stripes that provide ground for the signals (which will not function propperly if they dont see ground) and for some models side stand reminder light (one wire is green with a white stripe, the other is black with a white stripe on the 82/83 1100E model, most other models too likely as Suzuki generally stuck with the same harness for most of their models) In the headlamp bucket, there will be a brown wire that terminates to nothing, as well as a ground that terminates to nothing. These are uses for suplementary power for accessories or other power requiring devices (such as a phone charger, mp3 player, etc) I cannot remember however, if they are switched power or not. Id assume they are, but I may be wrong.

              Comment

              • blowerbike
                Forum Guru
                GSResource Superstar
                • Aug 2008
                • 7057
                • Ohio Closer to KY Than Cleveland

                #8
                harness grounds are black w/ white tracers.
                one is near the battery box area and i think the other is over the carbs or there abouts.

                Comment

                • mudy851

                  #9
                  83 gs 1100 E

                  sorry fellows thats and 83 gs1100e what concerns me is the wires feeding out of the fuse block are overly warm is that normal

                  Comment

                  Working...