Stator Installation

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Anonymous

    #1

    Stator Installation

    From the GS Resource I have figured out that my stator is bad. I puchased a new one and removed the old one. On both the old and new stator there are 3 yellow leads. On the bike(85 GS700ES) there are 3 yellow connecting wires. There is no indication to differeciate the 3 yellow wires.

    How can I figure out what wire gets connected where?

    Help, Please???!!!
  • moto_dan

    #2
    Re: Stator Installation

    Originally posted by Todd Miller
    From the GS Resource I have figured out that my stator is bad. I puchased a new one and removed the old one. On both the old and new stator there are 3 yellow leads. On the bike(85 GS700ES) there are 3 yellow connecting wires. There is no indication to differeciate the 3 yellow wires.

    How can I figure out what wire gets connected where?

    Help, Please???!!!
    There is no difference between the yellow wires so just connect them to the yellow connecting wires.

    Comment

    • argonsagas
      Forum LongTimer
      Charter Member
      GSResource Superstar
      Past Site Supporter
      • May 2002
      • 18761
      • Toronto, Canada

      #3
      Agreed, the wires are all the same.


      Add a small item....clean the connections WELL !

      While you are doing that, clean up the Regulator/rectifier connections too, and if you don't already have one, add a separate ground wire between the R/R and the negative post on your battery.

      Comment

      • Anonymous

        #4
        Thats one we all are sure of.

        Comment

        Working...