One of my carbs is leaking. There's always gas on the drain screw and the side of the carb a little higher up. could this be an old seal that needs to be replaced or something more serious. Any ideas?
-
-
Could be the floats are damaged/worn, needle not seating properly, could be a few different things. -
Is there anything I can do to find out whats wrong or should I get someone who knows what there doing to look at it?Comment
-
Sounds like a leaking bowl gasket. First try tightening the screws. Use a good fitting short screwdriver. If that fails, buy a new gasket.And on the seventh day,after resting from all that he had done,God went for a ride on his GS!
Upon seeing that it was good, he went out again on his ZX14! But just a little bit faster!
Comment
Comment