What do I need?

[Anonymous]

I know i am going to need to rejet my carbs for the mods I am doing to my bike. BTW its a 78 GS550. I am putting pod filters and already have a Mac 4 into 1 megaphone exhaust. What do I need to get, and where would I get it from? Thanks

[Anonymous]

btt

[SqDancerLynn1]

Check this previous post- Info from the XS11 site but it pertains to all brands of MC

http://www.thegsresources.com/_forum/viewtopic.php?t=17814

[Anonymous]

Main jets:

1 jet size for custom 4 into 2 exhaust
2 jet sizes for 4 into 1 exhaust
1 jet size for K&N filter (single inside airbox)
1 jet size for drilling out the bottom of the airbox
3 jet sizes for individual filters
2 jet sizes for no muffler (open header)
Add up all the jet size increases and subtract one. (Remember they go in steps of 2.5 for each jet size)

Pilot jets:
1 pilot jet size for every 3 main jet size increase

so with the information from that thread, i would need to go up 4 main jet
sizes and 1 pilot jet size for the pod filters and 4-1 exhaust?

[SqDancerLynn1]

It's a good starting point

[KEITH KRAUSE]

bio...don't forget you'll need to raise the existing jet needles. Placing the needle clips 2 grooves lower than where they are now should be a good starting point. You must re-sinc' the carbs everytime you disturb the needles.