On my 78 1000e the fuel tank overflow tube seems to be dripping gas. A small spot on the garage floor in the moring. Is this just the gasket, or something internal in the sending unit. I really dont need the gage as it doenst read right anyway, so if i have to disable the gage to correct this it really wouldnt be a problem.
-
-
Try tightening the mounting screws -
Probably seeping around the gasket or 1 of the screws.Comment
-
if the gas is coming from the vent tube it is a internal leak and the sender will need to be replaced or sealed.Comment
-
I would try tightening the screws. Don't over tighten them. That rubber gasket lasts a long time. If it's bad, you should be able to buy a new one. I did about 4 years ago.And on the seventh day,after resting from all that he had done,God went for a ride on his GS!
Upon seeing that it was good, he went out again on his ZX14! But just a little bit faster!
Comment
Comment