1150 EF updating project

[Blower]

Will you be able to leave the blower on?

What does the blower need for oil flow / pressure?

Leave the blower on ??!!

Blower does not need any oil flow/pressure . Drive/(gear) end of the blower is lubricated with its own oil and the other end bearings are lubricated with some high speed vaseline .

And one more tihng , it?s more agressive looking in front of the engine

Ah..

I think all the old street bikes I have seen were setup with a draw thru carb. It looks like you will have to pull the header to get to the filter. Will you be able to leave the blower on?

What does the blower need for oil flow / pressure?

[Blower]

What was the reason you chose to put it up front?

To get more leg room ( belt drive ), better blower cooling , better flowing plenum/manifold and better fuel injector locating .
And one more tihng , it?s more agressive looking in front of the engine

Looks like your making some great progress. It will be interesting to see how well this thing runs once its done. We had an old blown Kaw street bike show up at the last all bike meet. Once again, the blower was behind the engine. What was the reason you chose to put it up front?

[Blower]

Not much progress on this week . Modified fuel tank to fit over fuel rail
and made stainless "pipe" to air cleaner .

You do realize that after all this teasing, when you finally have that thing running and hit the track with it, we want a video clip! :twisted:

Hopefully with a full audio track. This thing is going to sound sweet!

Un-be-leivable !!! NOW I DON'T KNOW WHETHER TO GO NUTS ON MY BIKE, OR LOCK MYSELF IN A ROOM AWAY FROM ALL TOOLS (could be safer).
Not to sideline this fascinating thread, but I am looking for a back wheel (3.5") from an 86 1150, to update the rear end of my 83 750 ES. Any chance you still have the original?

[Blower]

Blower intake with throttle body installed and first primary header pipes welded :



and the rest of the primary pipes :







All primary pipes are allmost same length ( +- 1/2" ) .

I am looking forward to seeing this bad boy complete. I just picked up an 1150and have been wondering what to do with it............
Great job for taking on such an extravagant project. So many turbos out there nice to see a blower.
FANTASTIC!!

How much compression are you going to run? Stock cams? and timing?
Very nice project, different!

[Blower]

Something like this? http://www.jscspeed.com/index.html?/univ/thermotec.htm

Yes . It maybe holds engine and blower a bit cooler .

Something like this? http://www.jscspeed.com/index.html?/univ/thermotec.htm

[Blower]

I?m going to route pipes on left side of engine , between front wheel and
blower intake . Is there any idea to wrap header pipes ?
Maybe next week I have somthing to show .

How ya going to route the header pipes around all that extra hardware up front??

You do realize that after all this teasing, when you finally have that thing running and hit the track with it, we want a video clip! :twisted: