Announcement

Collapse
No announcement yet.

Dimensions front sprocket cover mounting holes GSX1100

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Dimensions front sprocket cover mounting holes GSX1100

    Hi !

    For a GSX1100: Does anybody has a drawing with the location of the mounting holes of the front sprocket cover in relation to the output shaft ?

    I am looking to make a bearing support plate



    Thanks in advance, Ro

    #2
    Best IMO to make it a two piece setup. Plate spaced out as far as you need - and a bolt - in bearing carrier. 3 bolts with the carrier slotted. Once in place drill for another bolt with no adjustment. I'd also tie the base plate back to the frame as 6mm screws into the engine case won't carry much load at all.
    Wide tyre drag bike ?

    Comment

    Working...
    X