.png "Powered by vBulletin")
Never thought I'd say that my bike is running too well. OK, I've got about 60 miles on her since the carb rebuild and the valves reshimmed. Power difference is amazing. This is going to sound strange, but now the bike seems to have too much power too soon into the throttle. The bike idles fine, runs fine and has no flat spots straight through to 9k in any gear (1st through 4th is all I had the balls to do). Only a slight turn of the wrist and I'm off and pulling strong. Just seems to come on a little too fast for my liking. Almost like it has a faster cable pull then normal. At a steady 60mph in 5th gear, it only takes maybe a 1/4" turn of the wrist from off throttle to maintain it. Is this just my perception after riding it when it was so out of tune to now it running correctly? Compression has jumped from 130 to 150 across the board as well.
-
1980 GS1000GT (Daily rider with a 1983 1100G engine)
1998 Honda ST1100 (Daily long distance rider)
1982 GS850GLZ (Daily rider when the weather is crap)
Darn, with so many daily riders it's hard to decide which one to jump on next.
JTGS850GL aka Julius
GS Resource Greetings
-
Welcome to the world of a properly-running 850.
While you are enjoying that, though, keep in mind that the 850 is probably the slowest-accelerating four-cylinder GS.
If you pay attention, it also has a dual-range powerband.
Smooth and docile up to 6k, but take it over that, it's like somebody added a small shot of nitrous or grafted on a fifth cylinder.
.sigpic
mine: 2000 Honda GoldWing GL1500SE and 1980 GS850G'K' "Junior"
hers: 1982 GS850GL - "Angel" and 1969 Suzuki T250 Scrambler
#1 son: 1986 Yamaha Venture Royale 1300 and 1982 GS650GL "Rat Bagger"
#2 son: 1980 GS1000G
Family Portrait
Siblings and Spouses
Mom's first ride
Want a copy of my valve adjust spreadsheet for your 2-valve per cylinder engine? Send me an e-mail request (not a PM)
(Click on my username in the upper-left corner for e-mail info.) -
My previous bike didn't seem to be so off/on/off as this one and it was a 79 GS1000L so I was a little surprised at this from an 850. Maybe it's the shaft drive that I'm feeling as well.
1980 GS1000GT (Daily rider with a 1983 1100G engine)
1998 Honda ST1100 (Daily long distance rider)
1982 GS850GLZ (Daily rider when the weather is crap)
Darn, with so many daily riders it's hard to decide which one to jump on next.
JTGS850GL aka Julius
GS Resource Greetings
Comment
-
I used magic washers when I shimmed your needles.
1983 GS 1100E w/ 1230 kit, .340 lift Web Cams, Ape heavy duty valve springs, 83 1100 head with 1.5mm oversized SS intake valves, 1150 crank, Vance and Hines 1150 SuperHub, Star Racing high volume oil pump gears, 36mm carebs Dynojet stage 3 jet kit, Posplayr's SSPB, Progressive rear shocks and fork springs, Dyna 2000, Dynatek green coils and Vance & Hines 4-1 exhaust.
1985 GS1150ES stock with 85 Red E bodywork.
Comment
-
Dam good washers!!!
1980 GS1000GT (Daily rider with a 1983 1100G engine)
1998 Honda ST1100 (Daily long distance rider)
1982 GS850GLZ (Daily rider when the weather is crap)
Darn, with so many daily riders it's hard to decide which one to jump on next.
JTGS850GL aka Julius
GS Resource Greetings
Comment
-
short shift itGSX1300R NT650 XV535Comment
-
You may want to check where on the throttle grip the cable is connected. I noticed on my 450 that there were two connection points for the cable end pin.Comment
Comment