The Bandit swap and what I learned

[Mario]

Can you post or send me some pictures of the rear shock mounts that you welded to the Bandit swing arm? Did you have a shop do it? How costly was it? Did you also cut off the stock linkage area and weld a plate in its place?

http://www.thegsresources.com/_forum...d.php?t=215880

[Mario]

http://www.thegsresources.com/_forum...d.php?t=215880

i cut the old shock linkage mounting point off the swingarm and used a grinding wheel and file to smooth it out.

[Mario]

The initial shake down runs are almost complete. Have some DZUS fasteners on the way for the side covers. Going to try to use those. Then we have our Revival Rally on December 6th, vintage bike show. I will tear down after that and do the final tweaks and paint. I will take more pictures when doing the finishes.

[jwhelan65]

What about the front?

[jwhelan65]

I run 6 pot caliper on the exact same set up with no issues.

[Mario]

What about the front?

Front what?

[Mario]

I run 6 pot caliper on the exact same set up with no issues.

Your a better man than me. Have had no luck with these calipers. Two bikes, two set ups, same problems.