yoshimura valve colletts wanted

[jellywrestler]

i'm looking for some yoshi valve colletts for a gs1000r i'm putting back together, maybe someone has enough for one or two valves in their spares?

[rapidray]

If you are looking for shim UNDER buckets, Jay at APE has them.
Ray.

[GregT]

i'm looking for some yoshi valve colletts for a gs1000r i'm putting back together, maybe someone has enough for one or two valves in their spares?

Put up a pic Spyda. Showing valve stem dia - and where the raised ring comes on the inside.

[Guest]

Have you got the 6.6mm valve set up?

[jellywrestler]

Have you got the 6.6mm valve set up?

yip, it's a GS1000R yoshimura motor

[GregT]

So looking at the valve groove, it's a single step collet. No raised ring like later stuff, just an internal step like a British product.

I've made that type of collet for quite a few motors, it's not hard. I'd do them for you but the condition I'm in at present I don't trust myself on the lathe.
Got someone local to you - or Neville Mickelson ?

Waiting for a triple bypass - and not happy....